Post Reply
Posts: 1
Joined: Sun Jan 04, 2015 3:22 am


Post by Loren » Sun Jan 04, 2015 3:32 am

Couple of suggestions:

When a PUID of 0 is detected (under show system processes), PortExpert will show the ProcessName from the last process with a non-zero PUID instead of "system".

For listening processes (under show local connections), the remote address and remote port are not relevant, so it would be convenient to be able to see the local address and port. It is shown below, but maybe consider showing both local and remote address and port above.

Looks good so far.

Site Admin
Posts: 1298
Joined: Sun Jul 03, 2011 8:13 pm

Re: PortExpert

Post by Kyle_Katarn » Sun Jan 04, 2015 10:38 am

Post Reply